If you have a fire or water emergency, please call us now at (770) 924-3848

To have the optimal experience while using this site, you will need to update your browser. You may want to try one of the following alternatives:

Fire & Water - Cleanup & Restoration

8 Steps To Take When Flushing an Electric Water Heater

1/15/2019 (Permalink)

Turn off the valve of your water heater in Canton, GA

Hidden away in the garage or a closet is one of your home’s appliances that many people consider an essential part of modern life. Though it is often ignored for years, rarely dusted or checked, it is used in most residences multiple times a day. It’s the water heater.

So, what do you do when this important appliance begins making thumping, popping, or creaking noises? Although it may have a long life in Canton, GA, most heaters need your help in removing the sediment that can become trapped in the bottom pan.

Here is How To Do a Water Heater Flush

1. Cut the Power

Make sure you turn off any electricity moving into the heating unit before taking any further steps. This will prevent damage to the heating elements.

2. Turn off the Water

Shut the valve feeding water into the tub of the unit. There is often an inlet at the top of the tank that can easily be closed.

3. Begin to Drain

Attach a hose to the drain valve at the bottom of the water heater. Be sure it is secure to prevent leaks.

4. Open the Spigot

Open the pressure relief control and the spigot. This will allow the tank to drain.

5. Remove the Water

Be patient while the water drains. It may take several hours to remove all the liquid.

6. Close the Valves

When the tank is empty, close the drain valve and disconnect the drain hose. Now close the pressure relief control valve.

7. Open Hot-water Faucets

Open every hot water faucet in your home, except the tank’s. Then turn on the inlet at the top of the tank and allow the water to flow freely out of the faucets for at least three full minutes.

8. Close All Faucets

When the tank is full of water once again, close the spigots. If you have low water pressure, let the water run for more than three minutes. Call a water specialty team if you have concerns.

Restore power and use your water heater as normal. By cleaning the sediment from the bottom, you may have added years to the unit’s life.

Other News

View Recent Posts